热点科技

标题: 救急!I45为何不认副硬盘? [打印本页]

作者: annayue    时间: 2008-8-5 15:50
标题: 救急!I45为何不认副硬盘?
昨天入手新机器,系统\驱动什么的全装好了,开机一切正常,
U;Q6600.I45.GT9600COS.4G内存.希捷320G
然后接上我的一块320G的资料硬盘,进入到滚动条三四秒左右,就蓝屏了,试了几次都如此,取掉就正常启动.
后来换了店里一块250G的硬盘接上也能正常启动,
有没有兄弟碰到过这种情况,麻烦帮忙解决下!
作者: annayue    时间: 2008-8-5 16:49
蓝屏代码如下:
A problem has been detected and windows has been shut down to prevent damage to your computer.

If this is the first timeyou've seen this stop error screen,
restart your computer, If this screen appears again, follow thess steps:

check for viruses on your computer.Remove any newly installed
hard drives or hard drive controllers,check yourhard drive
to made sure it is properly configured and terminated.
Run CHKDSK/F to check for hard drive corruption,and then
restart your computer.

technical information;

***STOP:0x0000007B (0XBA4C3524,0XC0000034,0X00000000,0X00000000)
作者: dirk    时间: 2008-8-5 18:18
:a4:  不太清楚 帮你顶上去
作者: annayue    时间: 2008-8-5 18:32
都是串口,硬盘本身都没有问题,在JS那里副盘接别的电脑没有这种情况.
这块资料盘只有一个分区,也没有做系统.
一块是10代,一块是11代的
***STOP:0x0000007B (0XBA4C3524,0XC0000034,0X00000000,0X00000000)
这是蓝屏代码
作者: hhh0503    时间: 2008-8-5 18:58
320G的资料硬盘  你这个可能以前留数据了吧~
作者: zengronghk    时间: 2008-8-5 20:47
把内存弄成2G看看行不?如果不行那就换硬盘接口
作者: annayue    时间: 2008-8-5 23:45
以上都试过了没有
作者: you452    时间: 2008-8-6 09:53
在Bios常规检测中将数据盘检测关闭(不是禁用呀)以单盘方式进系统,Windows可正常检测数据盘
作者: wjdbb001    时间: 2008-9-9 21:00
bios设置问题吧
作者: hhh0503    时间: 2008-9-9 21:04
RAID关闭掉

[ 本帖最后由 hhh0503 于 2008-9-9 21:11 编辑 ]
作者: davidzmz    时间: 2008-9-10 00:13
具说10代和11代的混用有时会出问题。
作者: 浪漫如枫    时间: 2008-9-11 14:00
我是43的,但是好像我单接一块6和11或者两块都接也会有问题,但单接6的时候会出现楼主所说的那种滚动条到一半蓝屏的情况,单接11的话会不定时死机,不知道为什么...




欢迎光临 热点科技 (http://www.itheat.com/activity/) Powered by Discuz! X3.2