|
Q6600搭配P5Q-E具体要怎么设置?现在1.35稳定在3.6G,目标是4G稳定,应为杉木织草同学跟我说,我的Q6600要是能稳定运行在4G他就把他的I7吃下去:a36:想看杉木同学表演生吞CPU的大人多多指教了
现在出现了个很奇怪的问题....1.36可以很稳定的满载一个小时.但是会在CPU几乎空载的时候死机:a43: 比如聊Q或者泡论坛的时候:a28:
AI Overclock tuner: Manual
CPU Ratio Setting: 9
FSB Strap to North Bridge: auto
FSB Frequency: 400
PCI-E Frequency: 100
DRAM Frequency: 800
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: Manual
1st Information :
CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : A
Row Refresh Cycle Time: A
Write Recovery Time:A
Read to Precharge Time: A
2nd Information :
READ to WRITE Delay (S/D): A
Write to Read Delay (S): A
WRITE to READ Delay (D): A
READ to READ Delay (S): A
READ to READ Delay (D): A
WRITE to WRITE Delay (S): A
WRITE to WRITE Delay (D): A
3rd Information :
WRITE to PRE Delay: A
READ to PRE Delay: A
PRE to PRE Delay: A
ALL PRE to ACT Delay: A
ALL PRE to REF Delay: A
DRAM Static Read Control: DISABLED
RAM Read Training: DISABLED
EM. OC Charger: E
AI Clock Twister: A
AI Transaction Booster: auto
CPU GTL Voltage Reference (0/2): AUTO
CPU GTL Voltage Reference (1/3): AUTO
CPU PLL Voltage: 1.52V
FSB Termination Voltage: 1.26V
DRAM Voltage: 2v
NB Voltage: 1.28v
NB GTL Reference: AUTO
SBridge Voltage: 1.10V
PCIE SATA Voltage: 1.50V
Load Line Calibration: disabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : 200ps(400外频的话调到400PS都能开机，如果都430外频以上只能200PS以下才能开机)
NB Clock Skew : 100ps
Advance CPU Settings
CPU Ratio Setting: 9
C1E Suppport: Disabled
Max CPUID Value Limit: Disabled
Intel® Virtualization Tech: Disabled
Vanderpool Technology: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Disabled
我现在是参照这个设置的,各位高人给点修改意见啊:a31:
[ 本帖最后由 3716363 于 2008-11-29 17:50 编辑 ] |
|
收藏
